Electrolux / Westinghouse 1450970 Genuine External Filter with 1/4" Tube 350kpa / 50 PSI PLV FMP 350

Electrolux / Westinghouse 1450970 Genuine External Filter

with 1/4" Tube 350kpa / 50 PSI PLV FMP 350

GENUINE Electrolux / Westinghouse 1450970 External Filter
This is a Westinghouse, Frigidaire, Electrolux 1450970 REPLACEMENT FILTER 240396407, 1458682, AC139

External inline refrigerator water filter is a replacement cartridge for side-by-side refrigerators that have externally fitted cartridges replaces: External in-line Fridge Filter, 1450970 & many other filter part numbers, will fit all brands of fridges that use an external in-line fridge filter.
Most fridges with internal filters can be converted over to use these filters.

 Please note: packaging may vary at any time. Manufacturer may change their packaging design without prior notice.

Suitable for:
External inline refrigerator water filter is a replacement cartridge for side-by-side refrigerators that have externally fitted cartridges

Suits the Following Fridge Models
Electrolux model
ESE607WA*05, ESE607WA*06, ESE6977SC, ESE6077SC, WSE6070SB*7

Westinghouse
WSE6070SA, WSE6070PB*06, WSE6070SB*06, WSE607WB*06, WSE6970PA, WSE6970SA,
WSE6970WA,WSE6970WF ,WSE6970SF,WSE6970SE, WBE5160SCRH, WBE5160S,
WBE5160,WHE5160SA,WSE6070SA,WSE 6070SB*5

Electrolux fridge filter
ESE6977S, CESE6977SE, ESE6077SC, ESE6077SE, ESE6077SF, ESE6977SF, ESE6077SG, ESE6977SG,ESE6078WA,EHE5167SB

THIS FILTER ALSO SUIT FOR PART NUMBER 1456145K, 00740560, 1458682

This in-line filter is easy to fit with quick connect push-in 1/4" tube fittings suitable for plastic tubing and copper pipe.
5 micron rating will remove sediment, chemicals, bad taste, scale build up & odors.
1450970 EXTERNAL FILTER Operating Specifications are as Follows:
Flow Rate: 1.9 lpm (0.50 GPM)
Operating Temperature: min 2°C(35℉) - max 38°C(100℉)
Operating Pressure: 8.6 Bar(125 PSIG)
Technology: High quality Carbon Block
Function: Chemical and Mechanical Reduction
Capacity: 6,000 litres
Service Life: 12 months
Dimensions: approximately 250 mm x 50 mm
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Installation Instructions
This is for external compatible water filters with 1/4" pushfit connections.
You are buying Superior Quality compatible filters with push-fit connections.

Installation and replacement procedure for the Compatible External fridge water filter:
1. Find isolation valve which will be located somewhere on the water supply line to the fridge. Turn it off and to depressurise the system draw a large glass of water from the water outlet at the fridge.
2. Have a bucket and towel ready as there will be a small spillage of water during this process. Remove the old filter by depressing the locking collar at each end of the filter with your thumb nail (or similar) and at the same time pull out the water supply line. Discard the old filter.
3. Take the new filter, making sure the flow direction is correct and insert the inlet side only, the line will go in approx 5 – 10mm and you will feel it hit home.
4. IMPORTANT - Placing the filter in the bucket, turn on the water supply and allow about 5 litres of water to flow through the filter and into the bucket. This will remov e any loose carbon fines. Turn off the water supply and connect the line that feeds into the fridge. Turn on the water supply and run approx 2 litres through the system.
5. Complete the Replacement Due sticker and place in a visible area inside the fridge door.
Important: It is essential that operation, maintenance and filter replacement be carried out in accordance with manufacture's recommended procedures and guidelines for this product to perform as advertised. Failure to do so may void warranty
As with all built-in refrigerator water filters, the compatible external fridge water filter does not remove Fluoride.
Note: The filter provides cleaner, fresher water ice.
Important: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. The contaminants or other substances removed or reduced by the water filter device are not necessarily in your water

1/4" Tube 350kpa / 50 PSI Pressure Limiting Valve PLV Water Filter FMP 350

Stefani 350kpa Filter Accessory Press Reduce Valve
Replacing Filtamate FMP350 OR FMP 350
Watermark Certified

350kpa water pressure reducing valve
· High quality materials
· Light weight
· Easy installation

Pressure Limiting Valve 350Kpa 50psi Filter Protection Valve
- Pressure Reduction Valve with 1/4" Quick Connect Push Fit In and Out
Suitable for High pressure systems to protect drink dispensers e.g. Water filters, ice makers, coffee machines and reverse osmosis machines. Prevent water hammer and back flow.
- Australian/New Zealand Watermark Approved
Highly recommended when installing water filter systems.
- Integral Check Valve
- Resists water hammer.
- Stops backflow.

Pressure limiting valve in 350kpa with back flow prevention.
Watermark AS1357.2 Lic 23133
NSF : Certified to NSF/ANSI 61 Section 9
Limiting valve: 350kpa (50 PSI)
Flow: 7.5L/Min at 700 Kpa (100 PSI)
Max Pressure: 1600 Kpa (230 PSI)
Max Temperature: 40°C

	EXTERNAL WATER FILTER + HOSE (5M 1/4") KIT SET $50
	APEX FMP 350 KPA WITH 1/4" TUBE PORTS $39
	JOHN GUEST (1M 1/4") HOSE TUBING HIGH PRESSURE $5