How To Reset The Water Filter Indicator On Fisher&Paykel Fridge.

How To Reset The Water Filter Indicator On Fisher&Paykel Fridge.There are no products.

There are no products in this category.

How To Reset The Water Filter Indicator On Fisher&Paykel Fridge.

How To Reset The Water Filter Indicator On a Fisher&Paykel Fridge 24 Water filter (Ice & Water models only) All the water to your refrigerator is filtered to remove impurities through a cartridge located in a position of your choice outside the refrigerator. This will need changing approximately every 6 months.

■ There is a replacement indicator icon on the control panel which will appear when the filter needs replacing. It will flash, as a reminder, when water is dispensed.

■ Replacement cartridges are available from your authorised Fisher & Paykel Dealer. The details of the replacement cartridge are on the label on the cartridge.

Changing the water filter cartridge It is not necessary to turn off the water supply before attempting to change the water filter cartridge.

1 Grasp and firmly twist the cartridge in an anticlockwise direction (to the left when installed in the recommended orientation) as shown in Diagram 1.

2 Pull the cartridge away from the filter head (down when installed in the recommended orientation) as shown in Diagram 2. – It is not unusual for a few drops of water to be present when the filter is removed.

3 Discard old filter.

4 Filter installation: – Remove protective cap on spigot on head. – Push the cartridge up towards filter head while rotating it in a clockwise direction (to the right when installed in the recommended orientation) as shown in Diagram 3.

5 Reset filter indicator icon on the display (this will remind you when the filter is due to be replaced again)

6 Dispense 10 litres (10 qt) to flush the cartridge, removing trapped air and harmless carbon fines.

7 A few drips may appear out of the dispenser over the next few days as the remaining trapped air is cleared.