Everpure SS-IMF Cartridge EV979932

Based on 0 customers advices.
EVERPURE® SS-IMF CARTRIDGE 12 PK EV979932
INHIBITS MINERAL SCALE DEPOSITS AND PROVIDES CORROSION PROTECTION IN WATER-FED EQUIPMENT*
FILTER FEATURES:
Features Hydroblend™ compound, a unique blend
Translucent cartridge allows simple visual monitoring of product usage and ensure against wasteful premature cartridge replacement
Integral feed cartridge fits Everpure model IMF housings
SS-IMF fits all old style 8" IMF Housings
Spacer (EV3114-69) available for adapting SS-IMF to 10" bowl
Inhibits mineral scale deposits and provides corrosion protection in low flow water-fed equipment*
Patented design dispenses a controlled amount of Hydroblend™ for long-term protection and provides greater effectiveness than standard phosphate treatments
APPLICATIONS:
Ice / Water-using equipment
Installation Tips:
IMF housing not included
Install vertically with black O-band seal up
The SS-IMF may have a very tight fit into older style AR-9 heads. To facilitate installation, warm the top of the SS-IMF (with O-band seal still installed) by running it under hot water for 10 seconds and/or applying a small amount of foodgrade silicone lubricant to the inside of the O-band
Spacer (EV3114-69) available for adapting SS-IMF to 10” bowl Flushing is not required for ScaleStick® cartridges
Operation Tips:
Deliming of equipment prior to application is recommended but not required
Inspect ScaleStick® cartridges at least every six (6) months
Replace ScaleStick® before Hydroblend™ compound is completely dissolved
Pre-existing equipment scale may come loose and clog equipment. Remove any loose scale to assure satisfactory operation
Overall Dimensions: 6.875" L x 1.312" dia. (17.4 x 3.3 cm)
Capacity: Approximately six (6) months.
Capacity will vary depending on application and water usage.
On flow rates less than one (1) gpm(3.78 Lpm), capacities may be reduced*.
Service Flow Rate: Maximum 0.1 - 6 gpm (0.3 - 22.7 Lpm)*
Temperature: Maximum 150°F (65.5°C)* If inlet feed
water temperature is above 125°F(51.67°C) a hot water housing must be used.
*Not performance tested or certified by NSF
|
No reviews at this time.