THIS PRODUCT IS CURRENTLY OUT OF STOCK. PLEASE CLICK THE LINK BELOW.
GE In-Line External Water Filter GXRTDR
This is GENUINE GE External Filter Suit for All GE External In-Line Fridge Filters
This listing is for external compatible
water filters with 1/4" pushfit connections.
DISPATCH IN 24 HOURS
Suitable for: External compatible water
filters with 1/4" pushfit connections You are buying Superior Quality
compatible filters with push-fit connections.
GE In-Line Fridge Filter GXRTDR replaces older filter part number GXITQ, GXITQR, GXRTQ, GXRTQR.
Part Number Cross Reference: GXRTDR, GXRTD, GXITQ, GXITQR, GXRTQ, GXRTQR, WR97X10071, WR97X215, WR97X215R.
The GE GXRTDR inline filter reduces unpleasant taste and odor while minimizing dirt, rust and sediment.-he GE GXRTDR Inline Refrigerator Water Filter reduces chlorine taste and odor to deliver clean, delicious water to your refrigerator and icemaker.-
The GE GXRTDR inline water filter has been tested and certified to NSF / ANSI Standard 42 for the reduction of Chlorine and Class V Particulates.-GE has discontinued the GXRTQR filter and recommends using the GE GXRTDR inline filter in its place.-
The GE GXRTDR refrigerator filter life is up to 6 months or 2500 gallons depending on water usage and water quality.
The GXRTDR inline filter has 1/4-Inch quick connect fittings to install easily behind your refrigerator, with no special tools required. Simply insert your quarter inch water line into the ends of the GE GXRTDR filter.
Tested and Certified by NSF International against NSF/ANSI Standards
42 for the reduction of Chlorine Taste and Odour. As with all built-in refrigerator
water filters, the GE GXRTDR in-line fridge water filter does not remove Fluoride.
Note: The filter provides cleaner, fresher water & ice.
Important: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system.
The contaminants or other substances removed or reduced by the water filter device
are not necessarily in your water
Installation and replacement procedure for the GE GXRTDR in-line fridge water
filter:
1. Find isolation valve which will be located somewhere on the
water supply line to the fridge. Turn it off and to depressurise the system draw
a large glass of water from the water outlet at the fridge.
2. . Have a bucket and towel
ready as there will be a small spillage of water during this process. Remove the
old filter by depressing the locking collar at each end of the filter with your
thumb nail (or similar) and at the same time pull out the water supply line. Discard
the old filter.
3. Take the new filter, making sure the flow direction
is correct and insert the inlet side only, the line will go in approx 5 – 10mm and
you will feel it hit home.
4. IMPORTANT - Placing
the filter in the bucket, turn on the water supply and allow about 5 litres of water
to flow through the filter and into the bucket. This will remov e any loose carbon
fines. Turn off the water supply and connect the line that feeds into the fridge.
Turn on the water supply and run approx 2 litres through the system.
5. Complete the Replacement Due sticker and place in a
visible area inside the fridge door.
NOTE: The green light changes to
orange after five months to indicate that you should soon change the water filter.
It changes to red after an additional one month (6 months after the water filter
was changed or installed) to indicate that you must change the water filter. If
the water filter indicator lights up red, press the ICE TIMER and ICE MODE buttons
at the same time for about three seconds to reset the water filter indication light
from red to green.
The GXRTDR inline filter has 1/4-Inch quick connect fittings to install easily behind your refrigerator, with no special tools required. Simply insert your quarter inch water line into the ends of the GE GXRTDR filter.
Important: It is essential that operation, maintenance
and filter replacement be carried out in accordance with manufacture's recommended
procedures and guidelines for this product to perform as advertised. Failure to
do so may void warranty
IF YOU ARE NOT 100% SATISFIED WITH YOUR PURCHASE WE OFFER A FULL REFUND OR REPLACEMENT.
The GE GXRTDR In-Line
Water Filters Operating Specifications are as Follows:
Flow Rate
0.5 gallons per minute
Capacity
2,500 gallons or 6 months
Feed Water Pressure
25 - 125 psi.
Feed Water Temperature
35 - 100 F
Filter Media
Granular Activated Carbon (GAC)
Dimensions
2" x 14" x 2"
Overall Dimensions
2" H x 14" W x 2" D
Important: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system.